Mount And Blade Warband 1.153 Crack Skidrow nethmon
Judging by the extract from your lsusb, I assume you are using a Bluetooth keyboard. Sometimes, this kind of device can get a little confused about what input methods to use. Check in the BIOS that your keyboard is enabled for booting in BIOS setup mode. If it is enabled but not for booting, then turn it off. If it is not enabled at all, then chances are that your keyboard is not recognized at all. Also, do not blame Ubuntu for your errors. For one thing, it was not Ubuntu that messed up your partition table. If you cannot fix your partition table, then you will probably need to back up your data, reformat your hard disk, and repartition it from scratch. Back to your question, the first thing you should do is add a modeline to your xorg.conf, with a width and height of 1600 x 1200. The modeline (yes, a real word) is very simple. I used the following modeline to get 1280x1024 with a 1.4: Modeline "1280x1024_60.00" 85.75 1280 1360 1496 1720 1024 1025 1028 1060 1200 1201 1204 1208 + If you are using a laptop, you may have to change the refresh rate, to avoid tearing. I had to do this in a specific way because my monitor only had 2 timing modes: 85 hz and 100 hz. As a result, the monitor did not give me the correct refresh rate. I solved this by using a modeline that I took from the refresh rate manual: Modeline "1440x900_60.00" 85.75 1440 1488 1536 1664 900 901 903 908 1054 + Then, you will need to enable that modeline in the xorg.conf. I think this will solve the problem of not being able to get the correct refresh rate. A: Here is the list of TV tuners that could work (I have checked this on my system): Also, the use of /dev/dvb/adapter0/frontend may be deprecated and you should use /dev/dvb/adapter0/frontend1.